System Description

UTM-00355 | Rev 2

Page 32 of 261

Safety

The DigiShot

Detonator cannot be initiated by the CE4 Tagger. The CE4 Tagger is incapable of producing

the

required firing voltage and cannot produce the required ‘Fire’ command to initiate a DigiShot

Detonator.

EVER CONNECT ANY THIRD PARTY OR OTHER UNAPPROVED DETONATORS TO THE

IGI

HOT

YSTEM

Safety Warnings

User and Safety Tips

Risks

ANDLE MECHANICALLY DAMAGED

ETONATOR AS PER APPROVED PROCEDURES

EVER CONNECT

THE

ETONATOR TO ANY UNAPPROVED VOLTAGE SOURCE

EVER CONNECT THE

DETONATOR TO

ANY EQUIPMENT OTHER THAN A

CE4

AGGER WHILE ON THE BENCH

ETONATOR MAY BE

CONNECTED TO THE

ANGER AS PER LOCAL LEGISLATIVE REQUIREMENTS AND PRESCRIBED BLASTING

PRACTICES ON SITE WHICH MAY REQUIRE THE BENCH TO BE CLEARED FOR BLASTING BEFORE CONNECTION

TO A BLAST DEVICE IS ALLOWED

Destruction of 4G Detonators

Refer to Destruction of Shot Detonators document OPI-202 for guidelines. The guideline does not supersede those

required by local mine, explosives or statutory regulations/procedures/codes of practise regarding the use of 4G

detonators In such cases, the MOST STRINGENT set of rules between the mine, explosives or local

regulations/procedures/codes of practise and the manufacturer must be followed.



Always keep connectors closed when not in use to avoid damage and/or contamination.

Always ensure all the DigiShot

Detonators are connected to the system via the harness

wire before leaving the bench.

DigiShot

Detonators are impact sensitive and should always be handled with care.