Specifications
Table Of Contents
- 1. USERS OF THIS MANUAL
- 2. SYSTEM PRODUCT SAFETY
- 3. Warning, Caution, and Note Statements
- 4. DigiShot® Plus Base Station
- 4.1. Components
- 5. Base Station Accessories
- 5.1. RF Antennae
- 6. Setup and Configuring DigiShot® Plus Base Station
- 6.1. Charging the DigiShot® Plus Base Station
- 6.2. Battery Errors
- 6.3. Power Base Station On
- 6.4. Power OFF DigiShot® Plus Base Station
- 6.5. Menu Navigation
- 7. System Settings
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 3. Under System Settings
- 1. Display Remote Status Screen
- 1. Display Remote Status Screen
- 9. Operation
- 9.1. Testing and Programming Detonators
- 9.2. Reprogramming Bench Box(es)
- 9.3. Blast RF Mode
- 9.4. Exit the blast sequence without firing (disarming)
- 9.5. Permanent Abort
- 9.6. Programming Errors before Arming
- 9.7. High Leakage during Arming
- 9.8. Last Det Check
- 9.9. Synchronisation Errors
- 10. Specifications
- 11. Troubleshooting Error Codes
- 12. Blast Layout
- 12.1. Unsynchronised Multiple Bench Box Blasting
- 12.2. Synchronised Multiple Bench Box Blasting
UTM-00232 | Rev 9
DetNet South Africa Copyright © 2018
Page 8 of 51
LCD Display and Soft Keys
The LCD screen can display up to thirteen lines of text at a time, each with a
maximum of 26 characters.
All Errors and Status reports are displayed on the LCD Display.
The Soft keys will activate functions displayed above the soft key as an option in a
menu
Navigation Arrow Keys
The Navigational keys are used to navigate during actions where one may need to
move left, right, up or down in an active screen.
ENTER key
The Enter key is used to accept an on-screen activity/option.
Numerical Key Pad
The Numerical Key pad is used to enter numerical key options and or numerical
values.
Abort Key and Arm Key
Abort Key will immediately abort all further actions during blasting operations. As a safety
measure after the Abort Key is pressed, the blast will need to be re-set by removing the Smart
Key, restarting the Bench Box and Base Station and re-inserting the Smart key when prompted.
ARM key is disabled and not in use as the system is armed by means of a soft-key.