Installation Instructions

ManualsBrandsDesigner's Image ManualsBuilding materialsBlack Level Bracket Set - 4 pk

STEEL RAIL

INSTALLATION INSTRUCTIONS

LEVEL..............................................................2

STAIR..............................................................4

LEVEL & ANGLE BRACKET..........................6

EPN-51402

INSTRUCTIONS FOR SKUS:

171-0909, 171-0912, 171-0933, 171-0936

Summary of content (7 pages)

PAGE 1
INSTRUCTIONS FOR SKUS: 171-0909, 171-0912, 171-0933, 171-0936 STEEL RAIL INSTALLATION INSTRUCTIONS LEVEL..............................................................2 STAIR..............................................................4 LEVEL & ANGLE BRACKET..........................
PAGE 2
LEVEL RAIL INSTRUCTIONS 1. Determine the desired rail placement and snap a line on the deck to ensure all posts are aligned properly (Fig. 1). Ensure sufficient mounting structure exists in areas to receive posts. Install blocking where necessary. Plumb the posts, using the shims provided, and secure all posts in place (Fig. 2). 2. Place rail panel across the opening and adjust to ensure equal baluster spacing at each end (Figs. 3 & 4).
PAGE 3
LEVEL RAIL INSTRUCTIONS 3. Test fit the rail panel. Once a proper fit is ensured all cuts must be painted prior to final installation (Fig. 7). Set the panel in place. Pre-drill the screw holes using a 5/32" metal drill bit. Secure using the supplied selftapping panel attachment screws through the pre-drilled bracket holes (Fig. 8) (2 screws per bracket). 4. Place a bracket cover over the rail next to the bracket and slide the cover toward the post until it snaps into place (Fig. 9). 5.
PAGE 4
STAIR RAIL INSTRUCTIONS 1. Place a plank on the stair noses spanning from post to post. Place the stair panel on the plank across the opening and adjust for plumb ensuring equal baluster spacing at each end. Clamp the panel in place at this location (Fig. 12). 2. Assemble a stair mounting bracket. Hold the bracket (angled end) against the post face and in line with your stair panel, mark the rail at these locations. Repeat this for all 4 rail ends.
PAGE 5
STAIR RAIL INSTRUCTIONS 4. Insert the cut panel ends into the stair brackets ensuring all are properly oriented. Test the panel to ensure proper fit. Mark the position of the bracket on all 4 posts (Fig. 16). Once proper fit is ensured remove the brackets from the rail panel and paint all cuts (Fig. 17). 5. Separate the two bracket halves at all rail ends. Install the post half of each mounting bracket at the marks made in step 3 (Fig. 19) ensuring all brackets are properly oriented.
PAGE 6
LEVEL & ANGLE BRACKET INSTRUCTIONS 1. Establish the placement of the bottom of the level panel based on your desired rail height. Mark a line on your mounting surface at this height plus 1 1/8" to represent the top of the mounting bracket (Fig. 23). Make an intersecting mark representing the desired center line of your installed rail panel.
PAGE 7
WARRANTY This warranty is effective for products purchased after January 1, 2017. This warranty can be found online at www.BarretteOutdoorLiving.com/warranty. To register your product, visit www.BarretteOutdoorLiving.com/product-registration. In case of a warranty claim, call (877) 420-7245. CARE & MAINTENANCE While UltraDeck products are low maintenance, like any outdoor product, care must be taken to ensure the railing’s longevity.