Specification

24h
1.
2.
3.
2. Now place the integrated glass sink on the glued cabinet.
3. Do not use the sink instantly. Wait approximately for 24 hours for the Silicon glue to dry.
1. Apply continuous stream of quality silicon glue to the top of the cabinet where the
Attaching Counter Top To Cabinet
1.
2.
3.
4.
4. Now that the drain is installed, you can connect the trap
3. Tie up the rubber and metal mounting rings over the drain opening from beneath the
2. For only the overow sinks, make sure that the hole on the drain is aligned with the
1. After you have installed the sink and countertop on the cabinet, put the drain assembly
inside the hole in the sink and x it rmly.
Installing The Drain On The Sink
1.
2.
3.
4.
Hanging Mirror On The Wall
4. Hang the mirror on to the screws.
3. Insert the plastic plugs into the drilled holes. Insert screws into the plastic plugs. Leave
the screws at least 0.5” – 0.75” inches outside.
2. Find the studs on the wall and drill two holes inside the studs as per your measurement.
1. Measure the distance between the screw holes at the back
12"or 16"
CONTACT SUPPORT
PHONE: [phone]
EMAIL: [e-mail]
ADDRESS: 8715 Boston place, Rancho Cucamonga, CA. 91730
www.designelementusa.com
• Please read and understand this entire manual before attempting to
assemble, operate or install the product.
• During installation, handle the countertop and sink with optimum care.
• Once you add glue and t the countertop / sink, wait for 24 hours to let the
glue dry, before using your vanity.
SAFETY AND PRECAUTIONS
• Avoid using any type of rough cleaning material on top of the cabinet
nish.
• Use mild liquid soap and water-dampened soft cloth to remove stains
from the cabinet and to clean the integrated sink countertop.
• For the glass part of the mirror, use ammonia-free cleaning products.
CARE AND CLEANING
PACKING LIST
• Pre-assembled cabinet
• Integrated sink countertop
• 1 Mirror
• 4 Cabinet legs
• Mirror mounting screws
• Instruction Manual
WARRANTY
Design Element warrants cabinets, mirrors, nishes and ttings to be free
from defects in workmanship and materials under normal use and service
for a period of one (1) year.
Please report any damage or missing pieces of your vanity to us immedi-
ately. These things must be reported no later than 30 days from the date of
delivery.
BACK
FRONT
B36-DS-W
COLLECTION: Stanton
DIMENSIONS: W 35 3/8” | D 18” | H 35 3/8”
SKU CODE:
INSTRUCTION MANUAL
DRAWER
27 1/2”
35 3/8”
17 5/8”
29 7/8”
35 3/8”
29 1/4”
9 1/4”
10 5/8”
22 1/8”
18”
13 1/2”
3 7/8”
17 5/8”
34 5/8”