User`s manual

49
(Note 1) GS1 DataBar (RSS) represents: GS1 DataBar Omnidirectional (RSS-14), GS1 DataBar Truncated (RSS-14
Truncated), GS1 DataBar Limited (RSS-14 Limited), GS1 DataBar Stacked (RSS-14 Stacked), GS1 DataBar
Expanded (RSS Expanded), GS1 DataBar Stacked Omnidirectional (RSS-14 Stacked Omnidirectional), and GS1
DataBar Expanded Stacked (RSS Expanded Stacked).
(Note 2) These code ID marks are contained in code data.
(Note 3) Type 4 is a code ID mark system compliant with the AIM USA “Guidelines on Symbology Identifiers.” The “m”
suffix is a modifier character that differs depending upon options of individual symbologies as defined below.
Code Type
“m”
(Modifier
character)
Options
0 Model 1 QR Code
1 Model 2
A No FNC1 in the 1st character positions from start code
C FNC1 in the 1st character positions from start code
iQR Code
E FNC1 in the 2nd character positions from start code
0 mode 4, mode 5 MaxiCode
1 mode 2, mode 3
1 ECC-200
2 ECC-200 (FNC1 in the 1st or 5th character position from start code)
Data Matrix
3 ECC-200 (FNC1 in the 2nd or 6th character position from start code)
0 No options
1 FNC1 preceding the 1st message character
2D
codes
Aztec
2 FNC1 subsequent to the 1st character or digit pair
0 Scanning enabled, without a check digit
1 Scanning enabled, with a check digit
(Check digit transmission enabled)
Interleaved
2of5
3 Scanning enabled, with a check digit
(Check digit transmission disabled)
0 Scanning enabled, without a check digit
1 Scanning enabled, with a check digit
(Check digit transmission enabled)
Code 39
Code 39 Full
ASCII
3 Scanning enabled, with a check digit
(Check digit transmission disabled)
0 Scanning enabled, without a check digit
1 Scanning enabled, with a check digit
(Check digit transmission enabled)
Codabar
3 Scanning enabled, with a check digit
(Check digit transmission disabled)
0 No FNC1 in the 1st and 2nd character positions from start code
Bar
codes
Code 128
2 FNC1 in the 2nd character position from start code
Example: The code ID mark for Interleaved 2of5 with option “Scanning enabled, with a check digit (Check digit
transmission disabled)” is ]I3.
]: Flag character (ASCII 93h)
I: Code character (Interleaved 2of5)
3: Modifier character (See the table above.)
(Note 4) For code ID marks not compliant with the AIM USA “Guidelines on Symbology Identifiers,” same characters as
ones defined in Type 1 apply.