Operation Manual


ENGLISH
Simple
Version
Remote
Control
Playback
(Advanced)
Connections
Playback
(Basic)
Multi-
zone
GUISettings
Getting Started
Troubleshooting
Other
Information
Spec. Index
Part
Names
Install
1 2 4 53
This unit can perform 2.0/2.1 to 7.1-channel surround playback.
Here, we explain setup using the example of 5.1-channel speaker
playback.
FL FR
SW
C
SL
SR
120˚
22 – 30˚
Listening position
FL Front speaker (L) Install the surround speakers in a position
60 to 90cm higher than ear level.
Front
speaker
Surround
speaker
60 – 90 cm
GViewed from the sideH
•
FR Front speaker (R)
C Center speaker
SW Subwoofer
SL Surround speaker (L)
SR Surround speaker (R)
11
NOTE
Connect so that the speaker cable core wires do not protrude
from the speaker terminal. The protection circuit may be
activated if the core wires touch the rear panel or if the + and
– sides touch each other (vpage 76 “Protection Circuit”).
Never touch the speaker terminals while the power supply is
connected. Doing so could result in electric shock.
•
•
Speakers
Carefully check the left (L)
and right (R) channels and +
(red) and – (black) polarities
on the speakers being
connected to the this unit,
and be sure to interconnect
the channels and polarities
correctly.
Connecting the speaker
cables
Peel off about 10 mm of
sheathing from the tip of the
speaker cable, then either
twist the core wire tightly or
terminate it.
Speaker impedance
Front
4 – 16 Ω
Center
Surround
Connect
1 2 4 53
22
FL FR
SW
C
SL
SR
Subwoofer
with built-
in amplifier
Speaker cables
(sold separately)
Audio cable
(sold separately)
The “Simple Version” describes the installation, connection and setup methods for 5.1-channel speakers.
See page 36 for the installation, connection and setup methods for speakers other than 5.1-channel speakers.