Operation Manual

o
Speakers for ZONE2 / Speakers for ZONE3 /
Speakers for ZONE2/ZONE3 / Speakers for Bi-
Amp/ Speakers for 2ch/ Speakers for Front B
When “Assign Mode” is set to “9.1ch + ZONE2”, “9.1ch + ZONE3”,
“9.1ch + ZONE2/3-MONO”, “7.1ch + ZONE2/3”, “9.1ch (Bi-Amp)” or
“9.1ch + Front B” in the menu, select the speaker terminal from which
to output the channels to which the internal amplifier is assigned.
(v
p. 219)
HEIGHT 1：
The assigned channels are output from
the HEIGHT1 speaker terminals. The
height, ceiling, and Dolby Atmos Enabled
channels cannot be used.
HEIGHT 2
(Default)：
The assigned channels are output from
the HEIGHT2 speaker terminals. Up to
one set of height, ceiling, and Dolby
Atmos Enabled channels can be used.
SURROUND BACK：
The assigned channels are output from
the SURROUND BACK speaker
terminals. The surround back channel
cannot be used.
o
Floor
n
Layout
Select the floor speakers location.
5ch & SB
(Default)：
This layout combines a surround back
speaker with the basic 5-channel layout.
5ch：
This is a basic 5-channel layout that uses
front speakers, center speakers and
surround speakers.
Contents Connections Playback Settings Tips Appendix
221
Front panel Display Rear panel Remote Index