Operation Manual
7.1ch + Front B:
0
Setting to assign the power amplifiers
within this unit for connecting the second
set of front speakers.
0
You can switch between the desired
combination of front speakers A and
front speakers B.
Switch the front speaker using the “Front
Speaker” setting. (v p. 250)
o
Speakers for ZONE2 / Speakers for ZONE3 /
Speakers for ZONE2/ZONE3 / Speakers for Bi-
Amp/ Speakers for 2ch/ Speakers for Front B
When “Assign Mode” is set to “7.1ch + ZONE2”, “7.1ch + ZONE3”,
“7.1ch + ZONE2/3-MONO”, “7.1ch (Bi-Amp)”, “9.1ch/2ch Front” or
“7.1ch + Front B” in the menu, select the speaker terminal from which
to output the channels to which the internal amplifier is assigned.
(v
p. 232)
FRONT WIDE/HEIGHT2
(Default):
The assigned channels are output from
the FRONT WIDE/HEIGHT2 speaker
terminals. The front wide channel cannot
be used. Up to one set of height, ceiling,
and Dolby Atmos Enabled channels can
be used.
HEIGHT1:
The assigned channels are output from
the HEIGHT1 speaker terminals. The
height, ceiling, and Dolby Atmos Enabled
channels cannot be used.
SURROUND BACK:
The assigned channels are output from
the SURROUND BACK speaker
terminals. The surround back channel
cannot be used. Up to one set of height,
ceiling, and Dolby Atmos Enabled
channels can be used.
Contents
Connections Playback Settings Tips Appendix
235
Front panel Display Rear panel Remote Index