Operation Manual

z1
This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS:X or DTS signal is played.
z2
This item can be selected when a Dolby TrueHD, Dolby Digital or DTS signal is played.
z3
This item can be selected when a DTS:X signal that is compatible with the Dialog Control function is input.
z4
This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z5
During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z6
This setting is available when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v
p. 204)
z7
This item cannot be set when “Dynamic EQ” is set to “On”. (v
p. 161)
z8
This item cannot be set when Audyssey
®
Setup (Speaker Calibration) has not been performed.
z9
This item cannot be set when “MultEQ
®
XT” is set to “Off”.
(v
p. 161)
z10
This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
Contents Connections Playback Settings Tips Appendix
259
Front panel Display Rear panel Remote Index