Installation Sheet

2322
IMPORTANT: Once you have read the
glass safety label and the glass panels
have been properly adjusted, corner
protectors can be removed.
IMPORTANTE: Una vez que haya leído
la etiqueta de seguridad del vidrio y que
los paneles de vidrio se hayan ajustado
correctamente, se pueden quitar los
protectores de las esquinas.
IMPORTANT
During installation & use
the inner panel should be
closest to the shower head.
IMPORTANTE
Durante la instalación y
uso, el panel interno
debe estar más cerca
del mango de ducha.
Symptom: Alignment Recommended Action
1. The top of the glass panel is tilted away
from the wall jamb.
Remove the glass panel from the top track and raise the roller on the bracket closest to the wall jamb.
2. The bottom of the glass panel is tilted
away from the wall jamb.
Remove the glass panel from the top track and lower the roller on the bracket that is closest to the wall
jamb.
3. The glass panel does not touch the
bumper.
Determine whether glass panel top or bottom is closer to the wall, and then adjust the roller closest to
the wall per #1 or #2 above.
4. The top track is cut too short. New track kit must be purchased and top track must be cut correctly. See steps 20-22.
5. The bottom track is miscut. Seal as directed to ensure watertight seal. See steps 18 and 19. If additional sealant insufficient, new
bottom track may be required.
Symptom: Water Leaks Recommended Action
1. Water leaks between panels When showering, make sure the inside panel is closest to the showerhead wall.
2. Water leaks between wall jamb and the
glass panel.
For adjustment, see Symptom: Alignment.
3. Water leaks under the bottom track. Check for proper silicone sealant application. See steps 41 and 42. Apply more silicone sealant as
needed.
Symptom: Operation (open/close) Recommended Action
1. The outside panel is difficult to move. a. Ensure sufficient clearance exists between the bottom track and the glass panel. If needed, lower the
rollers to the next hole.
b. Ensure the panel is properly engaged over the bottom track. See steps 32 and 33.
c. Ensure the rollers are properly installed.
d. Clean any debris in the top track where the rollers operate.
2. The inside panel is difficult to move. a. Ensure sufficient clearance exists between the bottom track and the glass panel. If needed, lower the
rollers to the next hole.
b. Ensure the inside center guide is properly secured with self-tapping screws. See step 40.
c. Ensure the rollers are properly installed.
d. Clean any debris in the top track where the rollers operate.
Symptom: Maintenance Recommended Action
1. Excess noise or vibration. a. Check all fasteners and re-tighten as necessary.
b. Ensure bushings (CC) are installed in glass.
2. Track kit discoloration. Carefully review and follow Care and Cleaning instructions.
TROUBLESHOOTING