Installation Guide

4
2
1/8"-1/4"
Sealant applied
before panel
Finished sealant
bead
Wall panel
93967 Rev. A
1
Verify shower location is level, plumb, and square.
Check dimensions of existing base/oor to ensure
proper t of shower walls.
NOTE: Place cardboard in shower base to protect
surface while installing shower walls.
Install moisture resistant drywall. Leave a 1/8" to 1/4"
gap between the drywall and shower base.
NOTICE: Failure to leave a gap between the drywall
and base could lead to drywall water damage.
Remove center panel and mark the position of shower
walls using a pencil.
Dry t shower walls. Check that walls are level and
plumb. If needed, make adjustments.
4
3