Installation Guide

13 / 14 Series Installation
2
Cartridge Installation
C.
• Turn o water supplies.
• Remove cover (1) and bonnet nut (2)
from the body, if necessary.
• IF THIS IS NOT A THIN WALL
MOUNTING, the entire plasterguard (3)
may be removed.
FOR BACK TO BACK OR REVERSE
INSTALLATIONS (hot on right and cold
on left) insert the cartridge with the “hot
side” on the right.
• Slide bonnet nut (1) over the cartridge
and thread onto the body.
• Hand tighten securely.
B.
• Rotate the cartridge (1) so the words
“hot side” (2) appear on the left.
• Insert cartridge into valve body as
shown.
• Make sure the cartridge tubes and O-
rings (3) are properly seated in holes at
the base of the body.
• Ensure the keys on the body are fully
engaged with the slots in the body (4).
Back to back Installation
Normal Installation (changes not required)
Reverse
Installation
Cold
Hot
1
4
4
2
3
1
A.
1
2
3
672264 Rev. G