User Manual

DFZM-TS220
User Manual Sheet of 24 Sep. 5, 2012
Proprietary Information and Specifications are Subject to Change
21
The configuration data can be used by selecting the frequency band and Preset #3 from
the test set-up menu in the LCD on the evaluation board. The applicable Frequency band
will be shown below the "write" button and on the LCD on the evaluation board when the
configuration data has been reprogrammed.
The configuration data will be written to the MASTER device and transferred over the
air(using a fixed radio set-up) to the SLAVE device when the test is started. This means
the SLAVE device should be started before the MASTER device.
If the MASTER device have problems to send the configuration data over the air to the
SLAVE device, it might be that the devices are to close to each other. Make sure that the
devices are at least 2 meters from each other.
See the kit user guides for more details about the standalone PER test.