User's Manual

9
Safety functions
- Safety device: the appliance is tted with a safety
device which switches it o in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the mains socket for
a few minutes, remove the cause of overheating then
plug in again.
- Tip over safety device: a tip over safety device turns
the appliance o if it falls over or is positioned inappro-
priately in such a way as to jeopardise safety.
The appliance emits a beep and a dot ashes on the di-
splay. The appliance resumes operation a few seconds
after being placed in an upright position again.
Disposing of the appliance
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with hou-
sehold waste, but taken to an authorised waste se-
paration and recycling centre.
INTRODUCTION
Thank you for choosing a De’Longhi product.
Please take a few minutes to read these instructions.
This will avoid all risks and damage to the appliance.
Symbols used in these instructions
Important warnings are identied by the symbols below.
It is important to respect the warnings. Failure to respect the
warnings could lead to electric shock, serious injury, burns,
re or damage to the appliance.
Danger!
Failure to observe the warning may result in life threatening
injury by electric shock.
Important!
Failure to observe the warning could result in injury or
damage to the appliance.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
Please note:
This symbol indicates recommendations and important
information for the user.
DESCRIPTION
(see g. 1)
A ON/STAND-BY button
B +/- adjustment buttons
C MODE button (selects the operating mode)
D ECO plus” button
E Timer button
F Swing button
G Remote control receiver
H Indicator light
I Air intake grille
J Filter
USE
Installation
- The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the
same socket for other appliances.
Electrical connection
- Before plugging the appliance into the mains socket,
check that the mains power supply corresponds to the
value indicated on the rating plate and that the mains
power supply is adequate for the load.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/
EEC ON RADIO INTERFERENCE SUPPRESSION.
Mounting the base
- Fit the two parts of the base together, matching the
guide pins on the front with the recesses on the back
and snapping the two clips into place (g. A and g. B).
- Turn the appliance upside down and position the
assembled base on the appliance in order to couple
the two openings with the two tabs on the appliance,
tilting it as shown in gure C, consequently turn the
base down till the two frontal teeth snaps into position.
Operation and use
1. Plug into the mains socket.
2. The appliance emits a beep. The indicator light (H)
comes on and remains lit while the appliance is
powered.
3. The appliance switches to stand-by. A dot ashing
on the display means the tip over device has been
activated.
See paragraph: “Safety functions”.
4. Press the ON/STAND-BY (A) to turn the appliance on.
It begins heating the room according to the current
settings.