Instruction Manual

40
Selecting the quantity of coee in the cup
The appliance is set by default to automatically make the
following quantities of coee:
- espresso coee, when the button is pressed
(≃40ml);
- long coee when the button (≃120ml) is pressed;
- two espresso coees, when the button is pressed;
- two long coees, when the button is pressed�
To change the quantity of coee the appliance delivers
automatically into the cup, proceed as described below:
- press the button corresponding to the quantity to be
modied and hold it down until the light ashes and the
appliance starts delivering coee� Release the button;
- when the coee in the cup reaches the required level, press
the same button again to memorise the new amount�
The quantity of coee in the cup has now been programmed�
Adjusting the coee mill
The coee mill is preset in the factory to make coee correctly
and should not require adjusting initially�
However, if after making the rst few coees you nd that the
coee is too thin and not creamy enough or that delivery is too
slow (a drop at a time), this can be corrected by adjusting the
grinding adjustment dial (g� 13)�
Please note :
The grinding adjustment dial must only be turned when the
coee mill is in operation�
If the coee is delivered too slowly or
not at all, turn one click clockwise�
For fuller bodied creamier coee,
turn one click anticlockwise (do
not turn more than one click at a
time otherwise the coee could be
delivered a drop at a time)�
These adjustments will only be evident after at least 2 cups of
coee have been delivered�
If this adjustment does not obtain the desired result, turn the
dial another click�
Setting the temperature
To modify the temperature of the water used to make the
coee, proceed as follows:
1� With the appliance o and the main switch in the I
position (g� 3), press the button and hold it
down until the lights on the control panel come on�
2� Press the button to select the required
temperature:
LOW HIGH
3� Press the button to conrm the selection� The
lights go o�
Tips for a hotter coee
For a hotter coee, before delivery you are recommended to:
• rinse the appliance through by pressing the
button� Hot water ows out of the coee spouts and
heats the internal circuit of the machine so that the coee
delivered will be hotter�
• warm the cups with hot water (using the hot water
function);
• setahottercoeetemperature(seesection“Settingthe
temperature”)�
Making coee using coee beans
Important!
Do not use caramelised or candied coee beans as they could
stick to the coee mill and damage it�
1� Fill the container with coee beans (g� 9)�
2� Place under the coee spouts:
- 1 cup if you want one coee (g� 10);
- 2 cups if you want 2 coees (g� 11)�
3� Lower the spouts as near as possible to the cup� This makes
a creamier coee (g� 12)�
4� Press the button corresponding to the number of coees
required
5� Preparation begins and the light corresponding to the
selected button ashes on the control panel�
Once the coee has been made, the appliance is ready for use
again�
Please note :
• Whilethecoeemakerismakingcoee,deliverycanbe
interrupted at any moment by pressing one of the coee
buttons�
• Attheendofdelivery,toincreasethequantityofcoee
1 espresso 1 long coee
2 long coees2 espresso