Owners Manual

Figure 15. Removing the SATADOM

1. SATADOM 2. SATA connector SATA5

3. power cable 4. system board power connector

Installing the SATADOM

CAUTION: Many repairs may only be done by a certified service technician. You should only

perform troubleshooting and simple repairs as authorized in your product documentation, or as

directed by the online or telephone service and support team. Damage due to servicing that is

not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that are shipped with your product.

Follow the safety guidelines listed in the Safety instructions section.

1. Holding the SATADOM by its edges, position it so that the card edge connector aligns with the

onboard SATA connector 5 on the system board.

2. Press the SATADOM with your thumbs until it is fully seated.

3. Reconnect all the cables.

1. Reconnect the peripherals and connect the system to the electrical outlet.

2. Turn on the system, including any attached peripherals.