Setup Guide
Table Of Contents
- Dell Wyse ThinOS Version 8.6 INI Reference Guide
- Introduction
- Getting Started: Learning INI File Basics
- Parameters for wnos INI files only
- Parameters for wnos INI, {username} INI, and $MAC INI files
- Connect Parameter: Options
- TimeZone Parameter: Values
- Best Practices: Troubleshooting and Deployment Examples
Table 4. General Settings: wnos.ini files only (continued)
Parameter Description
NOTE:
For detailed instructions on how to configure Wyse
Management Suite in a wnos.ini file to enable the Wyse
Management Suite Agent on supported ThinOS clients,
refer to Knowledge Base Solution #23875, go to the
Knowledge Base at www.dell.com/support and search for
23875.
CAValidation—If the option is set to yes, then the Wyse
Management Suite agent will check the certificate when
connected to https server. Default value is yes.
Discover—If the option is set to yes, then the Wyse
Management Suite agent discovers the Wyse Management
Suite server, MQTT server and CA validation from DNS
Record. Default value is yes.
This parameter is disabled if it is not defined using the user INI
parameter after the initial configurations are received by the
thin client from Wyse Management Suite. The thin client fails
to collect the new Wyse Management Suite entries modified
in the DNS record. This parameter can be enabled after a
factory reset or if the user INI is set to Discover=yes.
IgnoreMqtt—If IgnoreMqtt=yes is specified, Wyse
Management Suite agent will not connect to MQTT server.
Default value is no.
DefaultUser={username, $SYS_VAR}
[Display={yes, no}]
[disable={yes/no}]
Specifies the default sign-on user. See System Variables for a
list of system variables for $SYS_VAR.
Display—If the value is set to yes, the username field in sign-
on window will be displayed. By default the value is set to no
and the field will be obscured with asterisks (*).
disable— If the value is set to yes, the user name field in
sign-on window is disabled.
DelayReboot={yes, no}
DelayReboot—If the value is set to yes, this parameter
enables the user to delay the reboot of the thin client when
the configurations are applied from Wyse management Suite.
All changes are applied on the next reboot of the thin client.
Default value is no.
Password=<sign-on password>
[disable={yes/no}]
[encrypt={no, yes}]
Password— Specifies the password as the sign-on
password. There is no minimum length. The maximum length is
64 characters.
In wnos.ini this sets as the default password. The system will
sign on automatically and not wait for username, password,
and domain entries.
Disable—If the value is set to yes, the password field in sign-
on window is disabled. Default is no.
encrypt - The default value is no. The options are used to
enable or disable an encrypted string for a password in the
INI file instead of clear text. If the value is set to yes, the
password in the INI is an encrypt string instead of clear text.
DisableButton={no, yes}
[DisableRestart={yes, no}]
Default is no.
Yes/no option to disable the power button.
Parameters for wnos INI files only 15