Dell Wyse 3040 monitor mount for 2017 P-series Dell monitors Installation guide
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. Copyright © 2017 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, Dell EMC and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents 1 Dell monitor using this mount......................................................................................................................... 4 2 Included in the kit.......................................................................................................................................... 5 3 Mounting the thin client.................................................................................................................................
1 Dell monitor using this mount Dell Wyse 3040 monitor mount for 2017 P-series monitors is designed to work with the following monitors: • P1917S • P2017H • P2217H with stand • P2217H without stand • P2317H • P2417H with stand • P2417H without stand • P2717H • P2418T • P2418HZ NOTE: This mount is only designed to work with the Dell monitors listed above. This should not be used with other monitors.
2 Included in the kit For Dell Wyse 3040 Parts provided in the kit include: 1 One Dell Wyse 3040 mount For P-series monitor mount Parts provided in the kit include: 1 One screw (M2.5x0.45) 2 Four screws (M4x0.7-6) 3 Four hex nuts (M4x0.
3 Mounting the thin client Use the following instructions for mounting the client to the P-series mount. 1 Attaching 3040 mount —Install 3040 mount on the P-series mount with the (4) M4x0.7 screws included in the kit. NOTE: The four clips that hold the Dell Wyse 3040 onto the mount must be in the horizontal orientation. 2 Attaching the Power Adaptor Holder —Slide the small hooks downward into the vertical slotted holes and the large hooks onto the top edge of the mount. Use the M2.5x0.
—Remove the four (4) monitor screws from the back of the monitor and set them aside. —Position the P-series mount's central section on the back of the monitor. Tilt and slide the mount’s top tabs into the dedicated tab slots, and then firmly slide down the bottom edge of the mount until it snaps in place. —Install the P-series mount to the back of the monitor using the four monitor screws set aside earlier (do not over-tighten).
4 Reinstalling the monitor stand— Insert the upper stand tabs into the dedicated space on the P-series mount and gently press down until the quick release button latches in. Place the monitor in the upright standing position. 5 Attaching the client— Place the client over the bracket and gently push the client untill it clicks. NOTE: The power button of the client must face upward.
7 Connecting cables- Make all desired connections, and then connect the power adapter’s AC power cord to an electrical outlet. NOTE: To remove the client, gently pull the client to release it from the mount.
