Operation Manual

78 Setting up for network printing
www.dell.com/supplies | support.dell.com
Verify the IP settings
1 Look under the “TCP/IP” heading on the network setup page to make sure the IP
address, netmask, and gateway are what you expected.
2 Ping the printer and verify that it responds. For example, at a command prompt on a
network computer type ping followed by the new printer IP address (for example,
192.168.0.11):
ping xxx.xxx.xxx.xxx
If the printer is active on the network, you will receive a reply.
Set up the queue on the server
1 Insert the Drivers and Utilities CD, and then click Next.
2 Click Install the printer on the Network, and then click Next.
3 Click On the Server or computer that will share the printer with other computers,
and then click Next.
4 Select both options to install the software and the User’s Guide on the server, and then
click Next.
5 Click the box to share the printer on this server.
6 Create a share name you want to use for the PCL driver and the PostScript driver.
Make it an obvious name for clients to easily find when they are browsing for a shared
printer.
7 Click Next.
8 Select TCP/IP, and then click Next.
If your network also uses NetWare, click NetWare Systems as well.
9 Make sure “Choose an existing port for the printer connection” is selected.
10 Set the Port Type to Network TCP/IP Port.
11 Specify a port name. Make it an obvious name for clients to easily find when they are
browsing for a shared printer.
12 Enter the printer IP address, for example, 192.168.0.11.
13 Click Finish.
14 Print a test page to verify the software is installed correctly.
15 Click Finish to exit.