Concept Guide

rft
rft test profile antenna-connectivity ap-name <name> [dest-mac <macaddr> [phy {a|g}| radio
{0|1}]]
rft test profile link-quality {ap-name <name> dest-mac <macaddr> [phy {a|g}|
radio {0|1}] | bssid <bssid> dest-mac <macaddr> | ip-addr <ipaddr>
dest-mac <macaddr> [phy {a|g}|radio {0|1}]}
rft test profile raw {ap-name <name> dest-mac <macaddr> [phy {a|g}|radio {0|1}] | bssid
<bssid> dest-mac <macaddr> | ip-addr <ipaddr> dest-mac <macaddr> [phy {a|g}|radio {0|1}]}
Description
This command is used for RF troubleshooting.
Syntax
Parameter Description Range
ap-name
Name of the AP that performs the test. —
dest-mac
MAC address of the client to be tested. —
phy
802.11 type, either a or g. a | g
radio
Radio ID, either 0 or 1. 0 | 1
bssid
BSSID of the AP that performs the test. —
ip-addr
IP address of the AP that performs the test.
Usage Guidelines
This command can run predefined test profiles for antenna connectivity, link quality, or raw testing. You should
only run these commands when directed to do so by a Dell support representative.
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide rft | 712