Concept Guide

704| provision-ap Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
The AP parameter values are written to the provisioning-ap-list. To reprovision multiple APs, the APs must be present
in the provisioning-ap-list. Use the show provisioning-ap-list command to see the APs that will be provisioned. Use
the clear provisioning-ap-list command to clear the provisioning-ap-list.
2. Use the copy-provisioning-params option to copy an AP’s parameter values to the provisioning-params
workspace.
3. Use the provision-ap options to set new values. Use the show provisioning-params command to display
parameters and values in the provisioning-params workspace. Use the clear provisioning-params
command to reset the workspace to default values.
4. Use the reprovisionall option to provision the APs in the provisioning-ap-list with the values in
provisioning-params workspace. All APs in the provisioning-ap-list automatically reboot.
The following are useful commands when provisioning one or more APs:
l show|clear provisioning-ap-list displays or clears the APs that will be provisioned.
l show|clear provisioning-params displays or resets values in the provisioning-params workspace.
l show ap provisioning shows the provisioning parameters an AP is currently using.
Example
The following commands change the IP address of the master controller on the AP:
(host) (config) #provision-ap
read-bootinfo ap-name lab103
show provisioning-ap-list
copy-provisioning-params ap-name lab103
master 10.100.102.210
reprovision ap-name lab103
Command History
Release Modification
ArubaOS 3.0 Command introduced.
ArubaOS 3.2 Introduced support for the mesh parameters, additional antenna
parameters, and AP location parameters.
ArubaOS 3.4 Introduced support for the following parameters:
l installation
l mesh-sae
l set-ikepsk-by-addr
l usb-dev
l usb-dial
l usb-init
l usb-passwd
l usb-tty
l usb-type
l usb-user