Concept Guide

show ipv6 firewall
show ipv6 firewall
Example
This example displays the status of all firewall configurations.
(host) #show ipv6 firewall
Global IPv6 firewall policies
-----------------------------
Policy Action Rate Port
------ ------ ---- ---------
Monitor ping attack Disabled
Monitor TCP SYN attack Disabled
Monitor IPv6 sessions attack Disabled
Deny inter user bridging Disabled
Deny all IPv6 fragments Disabled
Per-packet logging Disabled
Enforce TCP handshake before allowing data Disabled
Prohibit RST replay attack Disabled
Session Idle Timeout Disabled
Session mirror destination Disabled
Prohibit IPv6 Spoofing Disabled
Enable IPv6 Stateful Firewall Disabled
The output of this command includes the following parameters:
Parameter Description
Monitor ping attack
If enabled, the controller monitors the number of
ICMP pings per second. If this value exceeds the
maximum configured rate, the controller will
register a denial of service attack.
Monitor TCP SYN attack
If enabled, the controller monitors the number of
TCP SYN messages per second. If this value
exceeds the maximum configured rate, the
controller will register a denial of service attack.
Monitor IPv6 sessions attack
If enabled, the controller monitors the number of
TCP session requests per second. If this value
exceeds the maximum configured rate, the
controller will register a denial of service attack
sessions.
Deny inter user bridging
If enabled this setting prevents the forwarding of
Layer-2 traffic between wired or wireless users.
You can configure user role policies that prevent
Layer-3 traffic between users or networks but this
does not block Layer-2 traffic.
Deny all IPv6 fragments
If enabled, all IPv6 fragments are dropped.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ipv6 firewall | 1633