Concept Guide

show ip route
show ip route
counters
static
stats
Description
View the Dell controller routing table.
Syntax
Command Description
counters
Displays the number of routes present, categorized by type.
static
Include this optional parameter to display only static routes.
stats
Displays route statistics.
Usage Guidelines
This command displays static routes configured on the controller via the ip route command. Use the ip default-
gateway command to set the default gateway to the IP address of the interface on the upstream router or
switch to which you connect the controller.
Examples
The example below shows the ip address of routers and the VLANs to which they are connected.
(host) #show ip route
Codes: C - connected, O - OSPF, R - RIP, S - static
M - mgmt, U - route usable, * - candidate default, V - RAPNG VPN
Gateway of last resort is Imported from DHCP to network 0.0.0.0 at cost 10
Gateway of last resort is Imported from CELL to network 0.0.0.0 at cost 10
Gateway of last resort is Imported from PPPOE to network 0.0.0.0 at cost 10
Gateway of last resort is 10.15.231.185 to network 0.0.0.0 at cost 1
S* 0.0.0.0/0 [1/0] via 10.15.231.185*
O 10.15.228.0/27 [333/0] via 21.21.21.1*
O 12.12.12.0/25 [0/0] via 21.21.21.1*
O 22.22.22.0/24 [3/0] via 21.21.21.1*
O 23.23.23.0/24 [2/0] via 21.21.21.1*
O 25.25.25.0/24 [333/0] via 21.21.21.1*
…
V 201.201.203.0/26 [10/0] ipsec map
O 202.202.202.0/29 [0/0] via 21.21.21.1*
C 192.100.2.0/24 is directly connected, VLAN2
C 10.15.231.184/29 is directly connected, VLAN1
C 172.16.0.0/24 is directly connected, VLAN3
C 21.21.21.0/24 is directly connected, VLAN21
C 5.5.0.2/32 is an ipsec map 10.15.149.30-5.5.0.2
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ip route | 1619