Concept Guide

show firewall-cp
show firewall-cp [internal]
Description
Displays the captive-portal (CP) firewall policies on the controller.
Syntax
No Parameters
Example
The output of this command shows the CP firewall policies.
(host) #show firewall-cp
CP firewall policies
--------------------
IP Version Source IP Source Mask Protocol Start Port End Port Permit/Deny hits
contract
---------- --------- ----------- -------- ---------- -------- ----------- ---- -----
---
ipv4 any 6 21 21 Permit 0 test
ipv4 10.10.10.10 2.2.2.2 6 8 9 Permit 0
ipv4 2:2:2:2::2 1 1 2 Permit 0
Command History
Release
Modification
ArubaOS 3.4 Command introduced.
ArubaOS6.2
The IP Version parameter was added.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config or Enable mode on master or
local controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show firewall-cp | 1494