Service Manual

24 |Using MIBs Dell Networking W-Series Instant Access Point 6.2.1.0-3.4 | MIB Reference Guide
MIB Browsers
If you are using an application that is run through the Linux shell, the command would be as follows:
snmpget -v 2c -c <community name> <Instant IP address><MIB OID>
Figure 2 shows an example of submitting a command to obtain information.
Figure 2 Running the snmpget Command
Figure 3 shows how information may be obtained through a graphical user interface (GUI). The user
interface and the available features vary by application.
Figure 3 Graphical User Interface
NOTE
You do not have to set the SNMP community string and security parameters on each W-IAP as this
configuration is common to all W-IAPs and is inherited from virtual controller.