Concept Guide

1071| show ap debug bss-stats Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description
Tx Dropped After Retry
Number of frames dropped after an attempted retry.
Tx Dropped No Buffer
Number of frames dropped because the AP’s buffer was full.
Tx Missed ACKs
Number of retries triggered because an acknowledgement was not received.
Tx EAPOL Frames
Number of EAPOL frames transmitted
TX STBC Frames
Number of transmitted frames with Space-time block coding (STBC) enabled.
TX LDPC Frames
Number of transmitted frames with Low Density Parity Check (LDPC) enabled.
Tx WMM
Number of Wi-fi Multimedia (WMM) packets transmitted for the following
access categories. If the AP has not transmitted packets in a category type,
this data row will not appear in the output of the command.
l Tx WMM [BE]: Best Effort
l Tx WMM [BK]: Background
l Tx WMM [VO]: VoIP
l Tx WMM [VI]: Video
Tx Data <value> Mbps
Number of frames transmitted at the specified rate, (Mbps).
Tx Data Bytes
<value> Mbps
Number of bytes of data transmitted at the specified rate, (Mbps).
UAPSD OverflowDrop
Number of packets dropped due to Unscheduled Automatic Power Save
Delivery (U-APSD) overflow.
Tx Mgmt Bytes
Total management frame bytes transmitted.
Tx Beacons Bytes
Total number of Beacon frame bytes transmitted.
Tx AMSDU pkt count
Total number of AMSDU bytes transmitted.
Rx Last SNR
The last recorded signal-to-noise ratio.
Rx Last SNR CTL0
The signal-to-noise ratio for the last received data packet on the primary
(control) channel 0. This parameter is only displayed for APs operating in 40
Mhz mode.
Rx Last SNR CTL1
The signal-to-noise ratio for the last received data packet on the secondary
(control) channel 1. This parameter is only displayed for APs operating in 40
Mhz mode.
Rx Last SNR CTL2
The signal-to-noise ratio for the last received data packet on the secondary
(control) channel 2. This parameter is only displayed for APs operating in 40
Mhz mode.