Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
eth0 UP 0 Yes
Wifi-sta INIT 6 No
3G/4G INIT 7 No
Internet failover :disable
Max allowed test packet loss:10
Secs between test packets :30
VPN failover timeout (secs) :180
ICMP pkt sent :0
ICMP pkt lost :0
Continuous pkt lost :0
VPN down time :0
The output of this command provides the following information:
Column Description
Uplink preemption
Indicates if the uplink preemption is enabled.
Uplink enforce
Indicates if any uplinks are enforced.
Ethernet uplink eth0
Indicates if Ethernet uplink is configured.
Type
Indicates the type of the uplink.
State
Indicates the uplink status.
Priority
Indicates if any priority levels are assigned to the uplink.
In Use
Indicates if the uplink is in use.
Max allowed test packet loss
Indicates an allowed number of test packets that can be lost verifying
the Internet availability.
Secs between test packets
Indicates the frequency at which the test packets are sent to verify the
Internet availability.
VPN failover timeout (secs)
Indicates the number of seconds to wait, before trying a different uplink
when a VPN tunnel is down.
ICMP pkt sent
Indicates the number of ICMP packets sent to verify the Internet
availability for uplink switchover.
ICMP pkt lost
Indicates the number of ICMP packets lost.
Continuous pkt lost
Indicates if the packets are lost continuously.
VPN down time
Indicates the time since the VPN connection is unavailable.
Command History
Version Description
Dell Networking W-Series
Instant 6.2.1.0-3.3
This command is introduced.