Concept Guide

Column Description
Heartbeat DSCP
DSCP value of AP heartbeats (0-63).
Maintenance Mode
Shows if Maintenance mode is enabled or disabled. If
enabled, APs stop flooding unnecessary traps and
syslog messages to network management systems or
network operations centers when deploying,
maintaining, or upgrading the network. The controller
still generates debug syslog messages if debug
logging is enabled.
Maximum Request Retries
Maximum number of times to retry AP-generated
requests, including keepalive messages. After the
maximum number of retries, the AP either tries the IP
address specified by the bkup-lms-ip (if configured) or
reboots.
Request Retry Interval
Interval, in seconds, between the first and second
retries of AP-generated requests. If the configured
interval is less than 30 seconds, the interval for
subsequent retries is increased up to 30 seconds.
Number of IPSEC retries
The number of times the AP will attempt to recreate
an IPsec tunnel with the master controller before the
AP will reboot. A value of 0 disables the reboot.
Secondary master IP/FQDN
IP address or the FQDN value of the secondary master
controller.
AeroScout RTLS Server
IP address of an AeroScout real-time asset location
(RTLS) server.
RTLS Server configuration
This parameter contains the following information,
separated by colons.
l The IP address of the RTLS server to which the AP
sends RFID tag information.
l Number of the RTLS server port to which the AP
sends RFID tag information
l Shared secret key for the server
l Frequency at which packets are sent to the server,
in seconds
Telnet
Reports whether telnet access the AP is enabled or
disabled.
Disable RAP Tftp Image Upgrade
Displays if the TFTP image upgrade for RAP is enabled
or disabled.
Spanning Tree
Displays the status of spanning tree on the controller.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap system-profile | 1329