Concept Guide

show ap database-summary
show ap database-summary
Description
Show a general summary of access point information for this controller.
Usage Guidelines
Use this command to show the current number of active APs and Air Monitors. This command is also useful for
determining how many unprovisioned APs or duplicate APs are on the network. For full details on each AP
registered to a controller, use the command show ap database.
Examples
The output of this command shows that this controller can detect a total of five APs, four up, and one down.
AP Database Summary
-------------------
AP Mode Total Up Total Down Total Upgrading* Total Rebooting* RAP Up RAP
Down RAP Upgrading* RAP Rebooting*
------- -------- ---------- ---------------- ---------------- ------ -------
- -------------- --------------
Access Points 4 1 0 0 0 0
0 0
Air Monitors 0 0 0 0 0 0
0 0
Wired Access Points 0 0 0 0 0 0
0 0
Mesh Portals 0 0 0 0 0 0
0 0
Mesh Points 0 0 0 0 0 0
0 0
Spectrum Monitors 1 1 0 0 0 0
0 0
*Upgrading and Rebooting counts only reflect APs registered on this controller.
The output of this command includes the following information:
Column Description
Total Up
Total number of APs with an up status.
Total Down
Total number of APs with a down status.
IPSEC Up
Total number of APs with an active (up) IPsec tunnel.
IPSEC Down
Total number of APs with an inactive (down) IPsec tunnel.
Command History
Introduced in ArubaOS 3.0.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap database-summary | 1049