Release Notes

Configuration Steps CLI Commands UI Procedure
captive portal example.
NOTE: The SSID type guest is used in this example to enable
configuration of captive portal. However, corporate access
through VPN tunnel is still allowed for this SSID because the VLAN
associated to this SSID is a VPN enabled VLAN (20 in this
example).
8. Create access rule for
wired and wireless
authentication. In this
example, the rule
permits all traffic.
For wired profile:
(ap)(config)# wlan access-rule wired-port
(ap)(Access Rule "wired-port")# rule any any match
any any any
permit
For WLAN SSID:
(ap)(config)# wlan access-rule guest
(ap)(Access Rule "guest")# rule any any match any
any any permit
See
Configuring
AccessRules
for Network
Services
NOTE: Ensure that you execute the commit apply command in the Instant CLI before saving the configuration and
propagating changes across the W-IAP cluster.
Table 72: W-IAP Configuration for Scenario 2—IPSec: Single Datacenter with Multiple controllers for Redundancy
AP Connected Switch Configuration
Client VLANs defined in this example must be opened on the upstream switches in multiple AP deployments, as
client traffic from slave to master is tagged with the client VLAN.
Datacenter Configuration
For information on controller configuration, see Configuring a Controller for IAP-VPN Operations on page 233.
Ensure that the upstream router is configured with a static route pointing to the controller for the L3 VLAN.
Dell Networking W-Series Instant 6.4.2.0-4.1.1 | User Guide IAP-VPN Deployment Scenarios | 378