Concept Guide

Parameter Description
NOTE: ha-disc-onassoc parameter works only
when IP mobility is enabled and configured on the
controller.
Mobile IP
Shows if the profile has enabled or disabled IP
mobility.
Preserve Client VLAN
This parameter allows clients to retain their
previous VLAN assignment if the client
disassociates from an AP and then immediately re-
associates either with same AP or another AP on
same controller.
Remote-AP Operation
Shows when the virtual AP operates on a remote
AP:
l always—Permanently enables the virtual AP
(Bridge Mode only). This option can be used for
non-802.1X bridge VAPs.
l backup—Enables the virtual AP if the remote
AP cannot connect to the controller (Bridge
Mode only). This option can be used for non-
802.1X bridge VAPs.
l persistent—Permanently enables the virtual
AP after the remote AP initially connects to the
controller (Bridge Mode only). This option can
be used for any (Open/PSK/802.1X) bridge
VAPs.
l standard—Enables the virtual AP when the
remote AP connects to the controller. This
option can be used for any (bridge/split-
tunnel/tunnel/d-tunnel) VAPs.
Station Blacklisting
Shows if the profile has enabled or disabled
detection of denial of service (DoS) attacks, such
as ping or SYN floods, that are not spoofed deauth
attacks.
Strict Compliance
If enabled, the AP denies client association
requests if the AP and client station have no
common rates defined. Some legacy client stations
which are not fully 802.11-compliant may not
include their configured rates in their association
requests. Such non-compliant stations may have
difficulty associating with APs unless strict
compliance is disabled.
Multi Association
If enabled, this feature allows a station to be
associated to multiple APs. If this feature is
disabled, when a station moves to new AP it will be
de authorized by the AP to which it was previously
connected, deleting station context and flushing
key caching information
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show wlan virtual-ap | 2120