Reference Guide

24 | Security Messages Dell Networking W-Series Instant Access Point 6.2.1.0-3.4 | Syslog Messages Reference Guide
121035 RADIUS type not sent: [type:%s]
Description: Controller has a reference to a RADIUS type that will be dropped.
132000 xSec is enabled wired usersx
Description: Sec is enabled for wired users
132001 xSec is disabled for wired usersx
Description: Sec is disabled for wired users
132019 Station [name:%s] [mac:%m] was Machine authenticated
Description: Station successfully authenticated the machine account
132020 Station [name:%s] [mac:%m] failed Machine authentication update role [rl:%s]
Description: Station failed to authenticate the machine account
132021 Station [mac:%m] [bssid:%m] entered Held state
Description: Authenticator is in the held state for the specified station. In this state no
response from the station is accepted till the end of quiet period. This is done to avoid
DOS attacks.
132028 Dropping EAPOL request from Station [mac:%m] reason:AP [bssid:%m] [apname:%s]
only is configured for Static-WEP
Description: Station is trying to send EAP packets to AP that is only configured with
Static-WEP.
Recommended Action: Either configure your client to support static-WEP
authentication or configure the ssid-profile on the controller to support an 802.1x
authentication method.
132044 Enabled Stateful Radius“
Description: Stateful Dot1x is enabled. Controller will start monitoring EAPOL frames
to track authentication status.
132048 Disabled Stateful Radius“Stateful Dot1x is disabled.
Description: Controller will stop monitoring EAPOL frames to track authentication
status.
132066 Station[mac:%m] [bssid:%m] [apname:%s] [vl:%d] [gretype:%d] VLAN has been
updated
Description: Station VLAN has been changed.
Cause: This is because of VLAN derivation rules
132067 Cleaning up the Stateful AP Configuration
Description: Clear all the stateful dot1x configuration entries
132068 Removing all the Stateful config entries.
Description: Remove all stateful dot1 configuration entries.
132070 Removing trusted AP [mac:%m]
Description: Remove the Trusted AP with the specified MAC address.
132071 Added trusted AP [mac:%m]
Description: Add the trusted AP with the specified MAC address.
132086 “WPA [ver:%d] Key exchange failed to complete, de-authenticating the station
[mac:%m] associated with AP [bssid:%m] [apname:%s] “
Description: WPA key exchange failed to complete, deauthenticating the station
Table 8 Security Information Messages
Message ID Message and Description