Users Guide

Additional Configuration Tasks
This section describes the following additional tasks that can be performed after a W-IAP is set up:
l Configuring Virtual Controller VLAN on page 78
l Configuring Auto Join Mode on page 79
l Configuring Terminal Access on page 80
l Configuring Console Access on page 80
l Configuring LED Display on page 81
l Configuring Additional WLAN SSIDs on page 81
l Preventing Inter-user Bridging on page 82
l Preventing Local Routing between Clients on page 82
l Enabling Dynamic CPU Management on page 83
The following figure shows the additional configuration options available under the System>General tab:
Configuring Virtual Controller VLAN
The IP configured for the Virtual Controller can be in the same subnet as W-IAP or can be in a different
subnet. Ensure that you configure the Virtual Controller VLAN, gateway, and subnet mask details only
if the Virtual Controller IP is in a different subnet.
You can configure the Virtual Controller VLAN by using Instant UI or CLI.
Dell Networking W-Series Instant 6.4.0.2-4.1 | User Guide Initial Configuration Tasks | 78