Users Guide

l Trunk — Select this mode to allow the port to carry packets for multiple VLANs specified as allowed
VLANs.
b. Specify any of the following values for Client IP Assignment:
l Virtual Controller Assigned: Select this option to allow the Virtual Controller to assign IP addresses to
the wired clients. When the Virtual Controller assignment is used, the source IP address is translated for
all client traffic that goes through this interface. The Virtual Controller can also assign a guest VLAN to a
wired client.
l Network Assigned: Select this option to allow the clients to receive an IP address from the network to
which the Virtual Controller is connected. On selecting this option, the New button to create a VLAN is
displayed. Create a new VLAN if required.
c. If the Trunk mode is selected:
l Specify the Allowed VLAN, enter a list of comma separated digits or ranges 1,2,5 or 1-4, or all. The
Allowed VLAN refers to the VLANs carried by the port in Access mode.
l If the Client IP Assignment is set to Network Assigned, specify a value for Native VLAN. A VLAN that
does not have a VLAN ID tag in the frames is referred to as Native VLAN. You can specify a value within
the range of 1-4093.
d. If the Access mode is selected:
l If the Client IP Assignment is set to Virtual Controller Assigned, proceed to step 2.
l If the Client IP Assignment is set to Network Assigned, specify a value for Access VLAN to indicate the
VLAN carried by the port in the Access mode.
6. Click Next to configure internal or external captive portal authentication, roles and access rules for the guest
users.
In the CLI
To configure wired settings for:
(Instant AP)(config)# wired-port-profile <name>
(Instant AP)(wired ap profile <name>)# type <guest>
(Instant AP)(wired ap profile <name>)# speed {10 |100 |1000 |auto}
(Instant AP)(wired ap profile <name>)# duplex {half|full|auto}
(Instant AP)(wired ap profile <name>)# no shutdown
(Instant AP)(wired ap profile <name>)# poe
(Instant AP)(wired ap profile <name>)# uplink-enable
(Instant AP)(wired ap profile <name>)# content-filtering
(Instant AP)(wired ap profile <name>)# spanning-tree
To configure VLAN settings for a wired profile:
(Instant AP)(config)# wired-port-profile <name>
(Instant AP)(wired ap profile <name>)# switchport-mode {trunk|access}
(Instant AP)(wired ap profile <name>)# allowed-vlan <vlan>
(Instant AP)(wired ap profile <name>)# native-vlan {<guest|1…4095>}
To configure a new VLAN assignment rule:
(Instant AP)(config)# wired-port-profile <name>
(Instant AP)(wired ap profile <name>)# set-vlan <attribute>{equals| not-equals| starts-with|
ends-with| contains| matches-regular-expression} <operator> <VLAN-ID>| value-of}
Configuring Internal Captive Portal for Guest Network
In the Internal Captive Portal type, an internal server is used for hosting the captive portal service. You can configure
internal captive portal authentication when adding or editing a guest network created for wireless or wired profile
through the Instant UI or CLI.
Dell Networking W-Series Instant 6.4.0.2-4.1 | User Guide Captive Portal for Guest Access | 126