Reference Guide

24 | Security Messages Dell Networking W-Series Instant Access Point 6.3.1.1-4.0 | Reference Guide
132019 Station [name:%s] [mac:%m] was Machine authenticated.
Description: Station successfully authenticated the machine account.
132020 Station [name:%s] [mac:%m] failed Machine authentication update role [rl:%s].
Description: Station failed to authenticate the machine account.
132021 Station [mac:%m] [bssid:%m] entered Held state.
Description: Authenticator is in the held state for the specified station. In this state no
response from the station is accepted till the end of quiet period. This is done to avoid
DOS attacks.
132028 Dropping EAPOL request from Station [mac:%m] reason:AP [bssid:%m] [apname:%s]
only is configured for Static-WEP.
Description: Station is trying to send EAP packets to AP that is only configured with
Static-WEP.
Recommended Action: Either configure your client to support static-WEP
authentication or configure the ssid-profile on the controller to support an 802.1x
authentication method.
132044 Enabled Stateful Radius
Description: Stateful Dot1x is enabled. Controller will start monitoring EAPOL frames
to track authentication status.
132048 Disabled Stateful Radius“Stateful Dot1x is disabled.
Description: Controller will stop monitoring EAPOL frames to track authentication
status.
132066 Station[mac:%m] [bssid:%m] [apname:%s] [vl:%d] [gretype:%d] VLAN has been
updated.
Description: Station VLAN has been changed.
Cause: This is because of VLAN derivation rules.
132067 Cleaning up the Stateful AP Configuration.
Description: Clear all the stateful dot1x configuration entries.
132068 Removing all the Stateful config entries.
Description: Remove all stateful dot1 configuration entries.
132070 Removing trusted AP [mac:%m].
Description: Remove the Trusted AP with the specified MAC address.
132071 Added trusted AP [mac:%m].
Description: Add the trusted AP with the specified MAC address.
132086 WPA [ver:%d] Key exchange failed to complete, de-authenticating the station [mac:%m]
associated with AP [bssid:%m] [apname:%s].
Description: WPA key exchange failed to complete, deauthenticating the station.
132131 FIPS mode is enabled.
Description: FIPS mode is enabled.
132132 FIPS mode is disabled.
Description: FIPS mode is disabled.
132133 WPA Countermeasure is enabled.
Description: WPA Countermeasure is enabled.
Table 8 Security Information Messages
Message ID Message and Description