Concept Guide

Parameter Description Range Default
frr-high-wm
If the frame retry rate (as a percentage of total
frames in an AP) exceeds this value, a frame
retry rate exceeded condition exists. The
recommended value is 16%.
0-100 16%
frr-low-wm
After a frame retry rate exceeded condition
exists, the condition persists until the frame
retry rate drops below this value. The
recommended value is 8%.
0-100 8%
no
Negates any configured parameter. — —
Usage Guidelines
The event threshold profile configures Received Signal Strength Indication (RSSI) metrics. When certain RF
parameters are exceeded, these events can signal excessive load on the network, excessive interference, or
faulty equipment. This profile and many of the detection parameters are disabled (value is 0) by default.
Example
The following command configures an event threshold profile:
(host) (config) #rf event-thresholds-profile et1
detect-frame-rate-anomalies
Command History
This command was introduced in ArubaOS 3.0
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide rf event-thresholds-profile | 760