Concept Guide

wlan dot11k-profile
wlan dotllk <profile-name>
ap-chan-rpt-11a
ap-chan-rpt-11bg
bcn-measurement-mode {active-all-ch|active-ch-rpt|beacon-table|passive}
bcn-req-chan-11a
bcn-req-chan-11bg
bcn-req-time
clone <profile-name>
dot11k-enable
force-disassoc
handover-trigger-profile
lm-req-time
no ...
rrm-ie-profile
tsm-req-profile
tsm-req-time
Description
Configure a 802.11k radio profile.
Syntax
Parameter Description Default
<profile-name>
Name of this instance of the profile. The name must be 1-
63 characters.
“default”
ap-chan-rpt-11a
This value is sent in the 'Channel' field of the AP channel
reports on the 'A' radio. You can specify values in the range
34 to 165.
36
ap-chan-rpt-11bg
This value is sent in the 'Channel' field of the AP channel
reports on the 'BG' radio. You can specify values in the
range 1 to 14.
1
bcn-measurement-mode
Configures a beacon measurement mode for the profile.
l active-all-ch—Enables active beacon measurement
mode. In this mode, the client sends a probe request to
the broadcast destination address on all supported
channels, sets a measurement duration timer, and, at
the end of the measurement duration, compiles all
received beacons or probe response with the requested
SSID and BSSID into a measurement report.
l active-ch-rpt—In this mode, the client and returns a
report that contains a list of channels in a regulatory
class where a client is likely to find an AP, including the
AP transmitting the AP channel report.
l beacon-table—Enables beacon-table beacon
measurement mode. In this mode, the client measures
beacons and returns a report with stored beacon
information for any supported channel with the
requested SSID and BSSID. The client does not perform
beacon-
table
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide wlan dot11k-profile | 2278