Concept Guide

1848| show rf dot11a-radio-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Spectrum Load Balancing Mode channel
Spectrum Load Balancing Update Interval (sec) 30 seconds
Spectrum Load Balancing Threshold (%) 20 percent
Spectrum Load Balancing Domain N/A
Beacon Period 100 msec
Beacon Regulate Disabled
Advertized regulatory max EIRP 0
ARM/WIDS Override OFF
Reduce Cell Size (Rx Sensitivity) 0 dB
Management Frame Throttle interval 1 sec
Management Frame Throttle Limit 20
Maximum Distance 0 meters
RX Sensitivity Threshold 0 dB
RX Sensitivity Tuning Based Channel Reuse disable
Adaptive Radio Management (ARM) Profile default
High-throughput Radio Profile default-a
AM Scanning Profile default
The output of this command includes the following parameters:
Parameter Description
Radio enable Shows if the AP has enabled or disabled transmissions on this radio band.
Mode Access Point operating mode. Available options are:
l am-mode: Air Monitor mode
l ap-mode: Access Point mode
l apm-mode: Access Point Monitor mode
l sensor-mode: RFprotect sensor mode
High throughput enable
(radio)
Shows if high-throughput (802.11n) is enabled on the radio.
A high-throughput profile manages 40 Mhz tolerance settings, and controls
whether or not APs using this profile will advertise intolerance of 40 MHz
operation. (This option is disabled by default, allowing 40 MHz operation.)
A high-throughput profile also determines whether an AP radio using the
profile will stop using the 40 MHz channels surrounding APs or stations
advertise 40 Mhz intolerance. This option is enabled by default.
Very High Throughput-
Enable
Enable or disable support for Very High Throughput (802.11ac) on the
radio. This option is enabled by default.
Channel Channel number for the AP 802.11a, 802.11n, or 802.11ac physical layer.
Beacon Period Time, in milliseconds, between successive beacon transmissions. The
beacon advertises the AP’s presence, identity, and radio characteristics to
wireless clients.
Beacon Regulate If enabled, this option introduces randomness in the beacon generation so
that multiple APs on the same channel do not send beacons at the same
time, which causes collisions over the air. This option is disabled by default.
Transmit EIRP Maximum transmit power (EIRP) in dBm from 0 to 51 in .5 dBm increments.
Further limited by regulatory domain constraints and AP capabilities.