Reference Guide

Command/Parameter Description Range Default
rules.
rule
Creates an access rule.
You can create up to 128 access
control entries in an ACL for a user
role. However, it is recommended to
delete any existing configuration and
apply changes at regular intervals.
— —
<dest>
Allows you to specify the destination IP
address.
— —
<mask>
Specifies the subnet mask for the
destination IP address.
— —
<match>
l match—Indicates if the rule specific
to the destination IP address and
subnet mask matches the value
specified for protocol.
l invert— Indicates if the rule allows
or denies traffic with an exception
to the specified destination IP
address and subnet mask.
match
invert
—
<protocol>
Configures any of the following:
l Protocol number between 0-255
l any: any protocol
l tcp: Transmission Control Protocol
l udp: User Datagram Protocol
1-255 —
<sport>
Specifies the starting port number from
which the rule applies.
1-65534 —
<eport>
Specifies the ending port number until
which the rule applies
1-65534 —
dst-nat
Allows the W-IAP to perform
destination NAT on packets.
— —
src-nat
Allows the W-IAP to perform source
NAT on packets. When configured, the
source IP changes to the outgoing
interface IP address (implied NAT
pool) or from the pool configured
(manual NAT pool).
— —
<dst-nat-IP-address>
Specifies the destination NAT IP
address for the specified packets when
dst-nat action is configured.
— —
<dst-nat-port>
Specifies the destination NAT port for
the specified packets when dst-nat
action is configured.
— —
app <app>
Specifies a rule to allow or deny
access to a specific type of application.
To view the list —
Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide wlan access-rule | 535