Reference Guide

394 | show lacp status Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide
show lacp status
show lacp status
Description
This command displays the Link Aggregation Control Protocol (LACP) configuration status on a W-IAP.
Usage Guidelines
Use this command to view the LACP status on W-IAP220 Series devices. LACP provides a standardized means for
exchanging information with partner systems to form a dynamic link aggregation group. The LACP feature is
automatically enabled during W-IAP boots and it dynamically detects the AP if connected to a partner system with
LACP capability, by checking if there is any LACP Protocol Data Unit (PDU) received on either eth0 or eth1 port.
Example
The following example shows the output of the show lacp status command:
AP LACP Status
--------------
Link Status LACP Rate Num Ports Actor Key Partner Key Partner MAC
----------- --------- --------- --------- ----------- -----------
Up slow 2 17 1 70:81:05:11:3e:80
Slave Interface Status
----------------------
Slave I/f Name Permanent MAC Addr Link Status Member of LAG Link Fail Count
-------------- ------------------ ----------- ------------- ---------------
eth0 6c:f3:7f:c6:76:6e Up Yes 0
eth1 6c:f3:7f:c6:76:6f Up Yes 0
Traffic Sent on Enet Ports
--------------------------
Radio Num Enet 0 Tx Count Enet 1 Tx Count
--------- --------------- ---------------
0 0 0
1 0 0
non-wifi 2 17
The output of this command displays details such as the link status, number of ports, AP partner MAC address, and
the interface status.
Command History
Version Description
Dell Networking W-Series Instant 6.3.1.1-4.0
This command is introduced.
Command Information
W-IAP Platform Command Mode
W-IAP220 Series
Privileged EXEC mode