Users Guide

Container Description
Global Agent Settings Configure global parameters for OnGuard agents. Parameters include the
following:
l Allowed Subnets for Wired access: Add a comma-separated list of IP or
subnet addresses.
l Allowed Subnets for Wireless access: Add a comma-separated list of IP or
subnet addresses.
l Cache Credentials Interval (in days): Select the number of days the user
credentials should be cached on OnGuard agents.
l Delay to bounce after Logout (in minutes): Specify the number of minutes
that should elapse before OnGuard bounces the interface if OnGuard
remains disconnected.
l Enable OnGuard requests load-balancing: Enable this option to load
balance OnGuard authentication requests across ClearPass Policy Servers
in a cluster.
l Enable access over Remote Desktop Session: Enable this option to allow
OnGuard access via a Remote Desktop session.
l Enable to hide Logout button:Enable this option to hide the Logout button.
l Install VPNComponent: Enable this option to install the OnGuard VPN
component.
l Enable to use Windows Single-Sign On: Enable this option to allow use of a
user's Windows credentials for authentication.
l Keep-alive Interval (in seconds): Add a keep alive interval for OnGuard
agents.
l OnGuard Health Check Interval (in hours): Specify the number of hours that
OnGuard will skip health checks for healthy clients.
NOTE: Note the following information when you set the OnGuard Health Check
Interval parameter:
n You can set this parameter if OnGuard mode is set to health only.
n This parameter is valid only for wired and wireless interface types.
n This parameter is not applicable for the OnGuard Dissolvable Agent,
VPN, and other interface types.
You can also specify the health check interval in the Agent enforcement
(Configuration > Agent enforcement > New attribute) profile to create different
Agent Enforcement Profiles for different users.
l Support Team Email Address: Enter an email address that will automatically
populate the "To:" field in the user's email client when they send logs.
Policy Manager Zones Configure the network (subnet) for a Policy Manager Zone.
Agent Version Current agent version.
Agent Installers
Installer Mode
Specify the action to take when the Aruba VIA component is used to provide
VPN-based access.
l Do not install/enable Aruba VIA component.
l Install and enable Aruba VIA Component.
Table 274: OnGuard Settings
Dell Networking W-ClearPass Policy Manager 6.3 | User Guide Administration | 415