Users Guide

Dell PowerConnect W-650 Controller | Installation Guide About the W-650 Series Controller | 11
ExpressCard Slot
The W-650 Series is equipped with one ExpressCard slot, which can be used with an EVDO device.
Antennae Interfaces (W-651 Only)
The W-651 is equipped with an internal Access Point (AP). This AP can operate in 2.4 GHz and 5 GHz bands, in
a/b/g or n modes. Each appliance has three RP-SMA interfaces to attach the antennas included in this kit.
LED Status Indicators
Table 3 W-650 Series LED Status Indicators
LED Label Function Indicator Status
Power POWER Input Power Status Indicator On (Solid Green) Power on
Off No Power
Status STATUS Module Status Indicator On (Solid Green) Device is operational
On (Solid Red) Device failed or is in Standby
On (Solid Amber) Device is loading software
Off No power
1000Base-X Ports (SFP) LNK/ACT Link Status Indicator On (Solid Green) Link has been established
On (Flashing Green) Port is transmitting or receiving
data
Off No link on port
10/100/1000Base-T Ports LNK/ACT Link/Activity Status Indicator On (Solid Green) Link has been established
On (Flashing Green) Port is transmitting or receiving
data
Off No link on port
1000 Interface Speed On (Solid Green) 1000 Mbps
Off 10/100 Mbps
10/100/1000Base-T Ports
with PoE
LINK/ACT Link/Activity Status Indicator On (Solid Green) Link has been established
On (Flashing Green) Port is transmitting or receiving
data
Off No link on port
PoE PoE Status Indicator On (Solid Green) PoE is being provided
On (Solid Amber) The attached device has
requested PoE, but PoE is not
being provided by the port
Off PoE is not being provided
802.11 a/b/g/n AP
(W-651 Only)
WLAN AP Status On (Solid Amber) Radio enabled in WLAN mode
On (Solid Green) Radio enabled in 802.11n mode
On (Flashing Green) Air monitor mode
Off Radio is disabled