Users Guide

Dell PowerConnect W-650 Controller | Installation Guide W-650 Series Installation | 13
Chapter 2
W-650 Series Installation
Pre-Installation Requirements
The following tools and equipment are required for installation of a W-650 Series controller.
z Rack Mount Bracket (x2, not used for tabletop installation)
z Suitable Screwdrivers
z AC Power Cord (country-specific)
z Left and right side bezels (not used for rack mounting)
For a Telecom Rack:
z M3, 6mm x 0.5mm Phillips Head Screws (6x, included)
z 12-24 x 5/8” Phillips Head Screws (4x, included)
For a Server Rack:
z M3, 6mm x 0.5mm Phillips Head Screws (6x, included)
z M6 x 20mm Phillips Head Screws (4x, included)
z M6 Cage Nuts (4x, included) or M6 Cage Clips (4x, included)
Installation in a Telecom Rack
To install a W-650 Series controller into a 19-inch (48.26 cm) Telecom rack system:
1. Place a rack mount bracket over the mounting holes on one side of the controller (see Figure 6).
2. Secure the bracket to the controller using three M3, 6mm x 0.5mm phillips head screws and a screwdriver.
3. Repeat these steps on the opposite side of the controller.
Warning: Before performing the following procedure, review the safety instructions that came with the controller.