Reference Guide

475 | interface port-channel Dell Networking W-Series ArubaOS 6.4.x| User Guide
interface port-channel
interface port-channel <id>
add {fastethernet|gigabitethernet} <slot>/<port>
del {fastethernet|gigabitethernet} <slot>/<port>
description <LINE>
ip access-group <acl> {in|out|session {vlan <vlanId>}}
jumbo
no ...
shutdown
spanning-tree [portfast]
switchport {access vlan <vlan>|mode {access|trunk}|
trunk {allowed vlan {<vlans>|add <vlans>|all|except <vlans>|remove <vlans>|
native vlan <vlan>}
trusted {vlan <word>}
xsec {point-to-point <macaddr> <key> allowed vlan <vlans> [<mtu>]|vlan <vlan>}
Description
This command configures an Ethernet port channel.
Syntax
Parameter Description Range Default
port-channel
ID number for this port channel. 0-7 —
add
Adds the specified FastEthernet or GigabitEthernet
interface to the port channel.
You cannot specify both FastEthernet and
GigabitEthernet interfaces for the same port
channel.
— —
del
Deletes the specified FastEthernet or
GigabitEthernet interface to the port channel.
— —
description <LINE>
A character string describing this port-channel. up to 60
characters
—
ip access-group
Applies the specified access control list (ACL) to
the interface. Use the ip access-list command to
configure an ACL.
NOTE: This command requires the PEFNG license.
— —
in
Applies ACL to interface’s inbound traffic. — —
out
Applies ACL to interface’s outbound traffic. — —
session
Applies session ACL to interface and optionally to
a selected VLAN associated with this port.
— —
jumbo
Enable or disables jumbo frame MTU configured via
firewall on a port channel.
Disabled