Reference Guide

ids wms-local system-profile
ids wms-locals-profile <profile>
max-rbtree-entries <number>
max-system-wm <number>
max-threshold <number>
system-wm-update-interval <number>]
Description
This command sets the local configuration parameters to control the size of the Wired MAC table and APs and
Stations.
Syntax
Parameter Description
max-rbtree-entries
Set the max threshold for the total number of AP and Station RBTree
entries.
max-system-wm
Set the max number of system wired MAC table entries learned at the
controller.
Range: 1-2000
Default: 1000
max-threshold
Set the max threshold for the total number of APs and Stations.
system-wm-update-interval
Set the interval, in minutes, for repopulating the system wired MAC table
at the controller.
Range: 1 to 30 minutes
Default: 8 minutes
Usage Guidelines
The wms-local system command is used for configuring commands that are local, not global. This means in a
master-local system, the configuration parameter is modifiable at each individual controller, and the setting on
one controller does not affect the setting on other controllers.
Increasing the max threshold limit will cause an increase in usage in the memory by WMS. In general, each entry
will consume about 500 bytes of memory. If the setting is bumped up by 2000, then it will cause an increase in
WMS memory usage by 1MB.
Example
The following commands first set the interval time for repopulating the MAC table to 10 minutes and then sets
the maximimum number of APs and stations to 500.
(host) (config) #ids wms-locals-profile system system-wm-update-interval 10
(host) (config)# ids wms-locals-profile system max-threshold 500
Dell Networking W-Series ArubaOS 6.4.x | User Guide ids wms-local system-profile | 460