Reference Guide

show interface gigabitethernet
show interface gigabitethernet <slot/module/port>
Description
Displays information about a specified Gigabit Ethernet port.
Syntax
Parameter Description
counters
Displays L2 interface counters for the specified interface.
switchport
Displays L2 interface information.
untrusted-vlan
Displays port member vlan untrusted status.
xsec
Displays xsec configuration.
Examples
The example below shows the output of show interface gigabitethernet 1/0.
(host)# show interface gigabitethernet 0/0/0
GE 0/0/0 is up, line protocol is up
Hardware is Gigabit Ethernet, address is 00:1A:1E:00:0D:09 (bia 00:1A:1E:00:0D:09)
Description: GE0/0/0 (RJ45 Connector)
Encapsulation ARPA, loopback not set
Configured: Duplex (AUTO ), speed (AUTO )
Negotiated: Duplex (Full), speed (1000 Mbps)
Jumbo Support is enabled on this interface MTU 9216
Last clearing of "show interface" counters 1 day 20 hr 32 min 38 sec
link status last changed 1 day 19 hr 37 min 57 sec
120719 packets input, 24577381 bytes
Received 84208 broadcasts, 0 runts, 0 giants, 780 throttles
0 input error bytes, 0 CRC, 0 frame
32939 multicast, 36511 unicast
19865402 packets output, 4953350248 bytes
0 output errors bytes, 0 deferred
0 collisions, 0 late collisions, 0 throttles
This port is TRUSTED
The output of this command includes the following parameters:
Parameter Description
GE 1/0 is...
Displays the status of the specified port.
line protocol is...
Displays the status of the line protocol on the
specified port.
Dell Networking W-Series ArubaOS 6.4.x | User Guide show interface gigabitethernet | 1554