Reference Guide

show ap remote debug association
show ap remote debug association [ap-name <ap-name>|bssid <bssid>|ip-addr <ip-addr>]
Description
Show the association table of the AP to identify the clients associated to each AP.
Syntax
Parameter Description
ap-name <ap-name>
Show client associations for a specific AP name.
bssid <bssid>
Show client associations for an specific AP Basic Service Set Identifier (BSSID).
The BSSID is usually the AP’s MAC address.
ip-addr <ip-addr>
Show client associations for an AP with a specific IP address. Enter the IP
address in dotted-decimal format.
Usage Guidelines
Use this command to verify if a remote user is connected to an AP, and to validate the AP to which is
connected.
Example
The output of this command displays information about the remote clients associated with an AP with the IP
address 192.0.2.32.
(host) #show ap remote debug association ip-addr 192.0.2.32
Flags: W: WMM client, A: Active, R: RRM client
PHY Details: HT: High throughput; 20: 20MHz; 40: 40MHz
<n>ss: <n> spatial streams
Association Table
-----------------
Name bssid mac auth assoc aid l-int essid
---- ----- --- ---- ----- --- ----- -----
AP71 00:0a:23:c1:d4:11 00:16:6d:08:1s:f1 y y 1 10 t-lab
vlan-id tunnel-id phy assoc. time num assoc Flags
------- --------- --- ----------- --------- -----
111 0x108e a 23s 1 A time
Num Clients:1
The output of this command includes the following information:
Column Description
Name
Name of an AP.
Dell Networking W-Series ArubaOS 6.4.x | User Guide show ap remote debug association | 1256