Reference Guide

Parameter Description
l Enhanced Adhoc Containment: Replay Response
Wired Containment Counters:
l Last Wired Containment Timer Tick
l Last Tagged Wired Containment Timer Tick
l Spoof frames sent
l Spoof frames sent on tagged VLAN
ids-state
Show IDS State.
ap-name
Name of Access Point
bssid
BSSID of Access Point
ip-addr
IP Address of Access Point
mesh-list
Show list of Mesh APs being monitored.
pot-ap-list
Display the Potential AP table. The Potential AP table shows the following
data:
l bssid: the AP’s Basic Service Set Identifier.
l channel: The AP’s current radio channel
l phy type: The radio’s PHY type. Possible values are 802.11a, 802.11a-HT-
40, 802.11b/g, 802.11b/g-HT-20.
l num-beacons: Number of beacons seen during a 10-second scan
l tot-beacons: Total number of beacons seen since the last reset.
l num-frames: Total number of frames seen since the last rest.
l mt: Monitor time; the number of timer ticks elapsed since the controller
first recognized the AP.
l at: Active time, in timer ticks.
l ibss: Shows if ad-hoc BSS is enabled or disabled. It will be enabled if the
bssid has detected an ad-hoc BSS (an ibss bit in an 802.11 frame).
l rssi: The Receive Signal Strength Indicator (RSSI) value displayed in the
output of this command represents signal strength as a signal to noise
ratio. For example, a value of 30 would indicate that the power of the
received signal is 30 dBm above the signal noise threshold.
pot-client-list
Display the Potential client table. The Potential Client table shows the
following values:
l last-bssid: the Last BSSID to which the client associated.
l from-bssid,
l to-bssid
l mt:Monitor time; the number of timer ticks elapsed since the controller first
Dell Networking W-Series ArubaOS 6.4.x | User Guide show ap monitor | 1214