Users Guide

Parameter Description
Channel for AP Channel
Reports in 'BG' band
This value is sent in the 'Channel' field of the AP channel reports on
the 'BG' radio. You can specify values in the range 1 to 14. The default
value is 1.
Time duration between
consecutive Beacon
Requests
This option configures the time duration between two consecutive
beacon requests sent to a dot11K client. By default, the beacon
requests are sent to a dot11K client every 60 seconds. However, if a
different value is required, the bcn-req-time option can be used.
This permits values in the range from 10 seconds to 200 seconds. A
value of 0 is used to indicate that the generation of Beacon Request
frames is turned off.
Time duration between
consecutive Link
Measurement Requests
This option configures the time duration between two consecutive link
measurement requests sent to an dot11K client. By default, link
measurement requests are sent to a dot11K client every 61 seconds.
This parameter permits values in the range from 10 seconds to 200
seconds. A value of 0 is used to indicate that the generation of Link
Measurement Request frames is turned off.
Time duration between con-
secutive Transmit Stream
Measurement Request
This option configures the time duration between two consecutive
transmit stream measurement requests sent to a dot11K client. By
default, the transmit stream measurement requests are sent to a
dot11K client every 90 seconds.
This permits values in the range from 10 seconds to 200 seconds. A
value of 0 is used to indicate that the generation of Transmit Stream
Measurement Request frames is turned off.
Handover Trigger Feature
Settings Profile
This command configures a Handover Trigger Profile. This profile
consists of the configurable parameters for the ‘Wi-Fi Edge Detection
and Handover of Voice Clients’ feature.
Beacon Report Request
Settings Profile
Configure a Beacon Report Request Profile to provide the parameters
for the Beacon Report Request frames.
TSM Report Request
Settings Profile
This command configures a TSM Report Request Profile which is used
to provide values to the Transmit Stream/Category Measurement
Request frame.
In the CLI
Use the following command to configure 802.11k profiles. The available parameters for this profile are
described in Table 94.
wlan dotllk <profile-name>
Configuring Radio Resource Management Information Elements
ArubaOS supports the following radio resource management information elements (RRM IEs) for APs with
802.11k support enabled. These settings can be enabled through the WebUI or CLI.
In the WebUI
To select the RRM IEs to be sent in beacons and probe responses using the WebUI:
1. Navigate to Configuration>Advanced Services>All Profile Management.
Dell Networking W-Series ArubaOS 6.4.x | User Guide Virtual APs | 484