Users Guide

l Global unicast—2000::/3
l Unique local unicast—fc00::/7
l Link local unicast—fe80::/10
In the WebUI
To Configure Link Local Address
1. Navigate to the Configuration > Network > IP page and select the IP Interfaces tab.
2. Edit a VLAN # and select IP version as IPv6.
3. Enter the link local address in the Link Local Address field.
4. Click Apply.
To Configure Global Unicast Address
1. Navigate to the Configuration > Network > IP page and select the IP Interfaces tab.
2. Edit a VLAN # and select IP version as IPv6.
3. Enter the global unicast address and the prefix-length in the IP Address/Prefix-length field.
4. (Optional) Select the EUI64 Format check box, if applicable.
5. Click Add to add the address to the global address list.
6. Click Apply.
To Configure Loopback Interface Address
1. Navigate to the Configuration > Network > Controller page and select the System Settings tab.
2. Under Loopback Interface enter the loopback address in the IPv6 Address field.
3. Click Apply.
You cannot configure the management interface address using the WebUI.
In the CLI
To configure the link local address:
(host)(config)#interface vlan <vlan#>
(host)(config-subif)#ipv6 address <ipv6-address> link-local
To configure the global unicast address:
(host)(config)#interface vlan <vlan#>
(host)(config-subif)#ipv6 address <ipv6-prefix>/<prefix-length>
To configure the global unicast address (EUI 64 format):
(host)(config)#interface vlan <vlan#>
(host)(config-subif)#ipv6 address <ipv6-prefix/prefix-length> eui-64
To configure the management interface address:
(host)(config)#interface mgmt
(host)(config-subif)#ipv6 address <ipv6-prefix/prefix-length>
To configure the loopback interface address:
(host)(config)#interface loopback
(host)(config-subif)#ipv6 address <ipv6-prefix>
Configuring IPv6 Static Neighbors
You can configure a static neighbor on a VLAN interface either using the WebUI or the CLI.
Dell Networking W-Series ArubaOS 6.4.x | User Guide IPv6 Support |
202